 |
|
 |
|
MAS
Low Viscosity Epoxy Resin This
is the low viscosity resin that is used with any of the hardeners
listed below. The resin to hardener ratio is always 2 to 1.
The hardeners can be blended to modify your cure times depending
on your work shop temperature and your time frame requirements |
|
|
|
Please
Note:
All epoxy and varnish supplies must be shipped through FedEx.
For an accurate shipping estimate, please select FedEx on
the shipping screen. |
| |
|
MAS
Slow Hardener This
No Blush hardener works well in a temperature range of 70
to 90 degrees. At 70 degrees you will have a 24-36 hour green
cure stage that will allow you to recoat without sanding or
washing. The next coat will chemically bond to the uncured
epoxy. When we are working at our winter time 60 degree shop
we normally blend this slow hardener with 25% fast hardener
to end up with the same 24 hour green cure time. As long as
we don't go beyond 30% fast hardener on the hardener side
of the equation we won't have to worry about amine blush.
Remember, the resin to hardener ratio is always 2 to 1. |
|
 |
| |
|
| |
Please
Note: All
epoxy and varnish supplies must be shipped through FedEx.
For an accurate shipping estimate, please select FedEx on
the shipping screen. |
| |
|
 |
|
MAS
Fast Hardener As
stated above you can blend this with the slow hardener to
customize your cure times. If you use more than 30% fast hardener
on the hardener side of the equation you will have to be aware
of the possibility of amine blush. |
|
|
| |
|
Please
Note:
All epoxy and varnish supplies must be shipped through FedEx.
For an accurate shipping estimate, please select FedEx on
the shipping screen. |
| |
|
|
|
The
Newfound Woodworks, Inc. © 2006 - 2008 |
|
